Does your Plastic Injection Mold Need to Work Without Thermocouples?

Does your Plastic Injection Mold Need to Work Without Thermocouples?

 

For Plastics manufacturers, some of their plastic injection molds need to run in manual mode without a thermocouple connection, even when it is repowered, the controller should default back to Manual Mode.  Typically for safety reasons the most of the controllers on the market return to Normal mode (auto) after power is cycled.  This can require the operator to change the controller back to manual mode every time.  This can lead to costly errors on the production line and increase startup time.

 

In order to make the card more efficient for these operators, and reduce startup times DT Heaters and Controls New Upgraded Hot Runner Temperature Controller, allow you to program the manual function to be the default when power is cycled! This manual mode function of our temperature controller helps speed up your setup changeovers for hot runner systems that need to return to manual mode

 

For details please contact us!